Yamaha CL Editor Manuale del Proprietario Scaricare il pdf (Pagina 41)

CL Editor Owner’s Manual

If a MATRIX channel is selected

❏ CHANNEL SELECT (Channel selection)

Except for the fact that your editing applies to a MATRIX channel, this is the same as the channel selection for a MIX

channel (➥ p.37.)

❏ FROM MIX, ST/MONO(C)

1 FROM MIX, ST/MONO(C) send level

These adjust the send levels of the signals sent from the MIX

buses or STEREO/MONO buses to the MATRIX bus. The cur-

rent value is shown in the numerical box immediately below.

2 PRE (PRE on/off)

These select either PRE or POST as the position from which the

signal is sent from the MIX buses or STEREO/MONO buses to

the MATRIX bus. PRE EQ or PRE FADER is selected if this is

on, or POST FADER is selected if this is off. The PRE EQ/

FADER setting can be made in the Mixer Setup dialog box.

3 ON(FROM MIX, ST/MONO send on/off)

These are on/off switches for the signal sent from the MIX buses

or STEREO/MONO buses to the MATRIX bus.

4 Channel name

This section indicates the name of the MIX channel or STEREO/

MONO channel.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 96 97

Nessun commento

Yamaha CL Editor Manuale del Proprietario Pagina 41