
E
5-5
EMU00419
POWER TRIM/TILT WILL NOT
OPERATE
If the engine cannot be tilted up or down
with the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit, the engine can be tilted
manually.
1 Manual valve screw
EMU00421
1) Loosen the manual valve screw coun-
terclockwise until it stops.
2) Put the engine in the desired position,
then tighten the manual valve screw
clockwise.
001585
t
e
EMU01330
REPLACING FUSE
If a fuse has blown, remove the electrical
cover, open the fuse holder and remove the
fuse with a fuse puller. Replace it with a
spare one of proper amperage.
w
Be sure to use the specified fuse. An
incorrect fuse or a piece of wire may
allow excessive current flow. This could
cause electrical system damage and a
fire hazard.
NOTE:
If the new fuse blows again immediately,
consult a Yamaha dealer.
1 Electrical cover
2 Fuse holder
3 Fuse (20A, 30A, 100A)
4 Spare fuse (20A, 30A, 100A)
5 Fuse puller
Z250, LZ250
VZ225, VZ250
60V-9-13-5 7/28/03 5:38 PM Page 6
Commenti su questo manuale